© 1999-2017 Citrix Systems, Inc. All rights reserved. p.184https://docs.citrix.com
installed.
Packets per second
The total number of packets passing every second.
NICs
The names of the network interface cards used by the NetScaler instance, along with the virtual function assigned to
each interface.
Version
The build version, build date, and time of the NetScaler software currently running on the instance.
Host Name
The host name of the NetScaler instance.
Total Memory (GB)
The total memory being assigned to the NetScaler instance.
Throughput (Mbps)
The total throughput of the NetScaler instance.
Up Since
The date and time since when the instance has been continuously in the UP state.
#SSL Chips
The total number of SSL chips
assigned to the instance.
Peer IP address
The IP address of the peer of this NetScaler instance if it is in an HA setup.
Status
The status of the operations being performed on a NetScaler instance, such as status of whether inventory from the
instance is completed or whether reboot is in progress.
HA Master State
The state of the device. The state indicates whether the instance is configured in a standalone or primary setup or is
part of a high availability setup. In a high availability setup, the state also displays whether it is in primary or secondary
mode.
HA Sync Status
The mode of the HA sync status, such as enabled or disabled.
Description
The description entered while provisioning the NetScaler instance.
Viewing the Running and Saved Configuration of a NetScaler Instance
By using the Management Service you can view the currently running configuration of a NetScaler instance. You can also
view the saved configuration of a NetScaler instance and the time when the configuration was saved.
To view the running and saved configuration of a NetScaler instance
1. On the Configuration tab, in the left pane, expand NetScaler Configuration, and then click Instances.
2. In the NetScaler Instances pane, click the NetScaler instance for which you want to view the running or saved
configuration.
3. To view the running configuration, click Running Configuration, and to view the saved configuration, click Saved
Configuration.
4. In the NetScaler Running Config window or the NetScaler Saved Config window, you can view the running or saved
To Next Page
Loading...
Need help?
General
