© 1999-2017 Citrix Systems, Inc. All rights reserved. p.211https://docs.citrix.com
Under Network Settings, from the Management Interface drop-down menu, select the interface through which to
manage the instance, set the IP address and gateway for that interface. You can assign interfaces explicitly for high
availability and service. Select the parameters and then click Next.
Note: When assigning interfaces for management, high availability and service, make sure you assign the interfaces
based on supported combination of interfaces:
You can select the same interface for all three.
You can select a different interface for all three.
You can select the same interface for management and service, but select a different interface for high availability.
4. Click Finish, and then click Close. The instance will be created, booted, and configured with the selected IP address.
After you provision the instance, log on to the instance through SSH to complete the configuration. For details on how to
configure the BlueCat DNS/DHCP Server or place it under the control of BlueCat Address Manager, see the appropriate
BlueCat Administration Guide, available at https://care.bluecatnetworks.com.
To modify the values of the parameters of a provisioned BlueCat DNS/DHCP Server instance, from the BlueCat DNS/DHCP
Instances pane, select the instance that you want to modify, and then click Modify. In the Modify BlueCat DNS/DHCP
wizard, modify the parameter settings.
Note: If you modify any of the interface parameters or the name of the instance, the instance stops and restarts to put
the changes into effect.
Monitoring a BlueCat DNS/DHCP Instance
Updated: 2013-06-20
The SDX appliance collects statistics, such as the version of SDXTools running on the instance, of a BlueCat DNS/DHCP
instance.
To view the statistics related to a BlueCat DNS/DHCP instance
1. Navigate to BlueCat DNS/DHCP > Instances.
2. In the details pane, click the arrow next to the name of the instance.
Managing a BlueCat DNS/DHCP Instance
Updated: 2013-06-18
You can start, stop, restart, force stop, or force restart a BlueCat DNS/DHCP instance from the Management Service.
On the Configuration tab, expand BlueCat DNS/DHCP.
To start, stop, restart, force stop, or force restart a BlueCat DNS/DHCP instance
1. Click Instances.
2. In the details pane, select the instance on which you want to perform the operation, and then select one of the
following options:
Start
Shut Down
Reboot
Force Shutdown
Force Reboot
To Next Page
Loading...
