Citrix NetScaler SDX 8015 User Manual

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.309https://docs.citrix.com
Interface*— The interface through which clients connect to the Management Service. Possible values: 0/1, 0/2.
Default: 0/1.
XenServer IP Address*— T he IP address of XenServer hypervisor.
Management Service IP Address*— The IP address of the Management Service.
Netmask*— The subnet mask for the subnet in which the SDX appliance is located.
Gateway*— The default gateway for the network.
DNS Server— The IP address of the DNS server.
*A mandatory parameter
5. Click OK. Connection to the Management Service is lost as the network information was changed.
6. Connect the NetScaler SDX appliance’s management port 0/1 to a switch to access it through the network. Browse
to the IP address used above and log on with the default credentials.
7. Apply the new licenses. For instructions, see NetScaler SDX Licensing Overview.
8. Navigate to Configuration > System and, in the System Administration group, click Reboot Appliance. Click Yes to
confirm. You are now ready to provision the VPX instances on the NetScaler SDX appliance. For instructions,
see Provisioning NetScaler Instances.

Citrix NetScaler SDX 8015 Specifications

General

Brand	Citrix
Model	NetScaler SDX 8015
Category	Server
Language	English