174
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines : 6FZ - RFN 2003 # NEW FITTING 2003 #
(6) Crankshaft pinion.
(7) Accessories drive pulley.
(8) Washer.
(9) Screw.
The pinion (6) is fitted as an idler on the crankshaft.
The accessories drive pulley (7) is immobilised on the crankshaft by a half-moon keyway and
by the tightening of washer (8) and screw (9).
A:Pegging on manual gearbox.
B : Pegging on automatic gearbox.
The pegging of the crankshaft is done on the flywheel, or on the converter drive plate (auto-
matic gearbox).
The pegging hole on the cylinder block (exhaust end) is calibrated and reinforced.
IMPERATIVE : Never turn the crankshaft with the accessories drive pulley slackened.
IMPERATIVE : Never remove the accessories drive pulley without pegging the
crankshaft and the camshafts.
IMPERATIVE : Always turn the crankshaft in the direction of engine rotation.
B1EP1B9D
B1BP2V2D
XSARA - XSARA PICASSO
To Next Page
Loading...
