EN
ENGLISH
Clarke
®
Operator's Manual (EN) - Image 16 I/IX 120V - 7 -
HOW TO PREPARE THE MACHINE FOR OPERATION
WARNING: This machine has moving parts. To reduce the
risk of injury unplug before servicing.
WARNING: To reduce the risk of fire, use only commercially
available floor cleaners and waxes intended for
machine application.
WARNING: Do not use water that is hotter than 140° F.
WARNING: Operating a machine that is not completely or
fully assembled could result in injury or property
damage. Do not operate this machine unless it
is completely assembled. Inspect the machine
carefully before operating.
This machine is intended for commercial use.
Flush rinse tank and chemical tank completely.
To prepare the machine for operation, follow this procedure:
1. Select the correct type brush for your application. Choose either
the interim or restoration brush.
NOTE: Brushes Available: 14671A-Brush, Interim Assembly,
14657A - Brush, Restoration Assembly
To change the brush type, follow these instructions:
a. Remove left brush pivot screw.
b. Remove one (1) brush retainer screw and loosen the other
retainer screw.
c. Rotate brush retainer plate to the side.
d. Grasp brush on drive end (right side) pull brush toward the
steel brush plate.
e. Pull left side of brush out of housing and slide brush
assembly from drive mechanism.
To reassemble, follow these instructions:
a. Align brush drive slots with brush drive pin.
b. Apply pulling pressure to the brush drive end (pulling toward
the steel brush plate), apply end pressure to the left end of
the brush and slide brush assembly into the brush housing.
c. Insure that the two (2) marks can be seen on the brush pivot
after brush assembly is in place.
d. Align the brush retainer and install the brush pivot screw.
e. Tighten both brush retainer screws.
2. Before moving the extractor onto the carpet, put clean hot water
into the solution tank. The solution tank capacity is approxi-
mately seven gallons.
3. For Image 16i only: Add two to ten ounces of Clarkare
®
Extractor
Concentrate" per every one gallon of water, depending on carpet
condition.
4. If the extractor removes an excess amount of foam from the
carpet, add a defoamer such as Clarkare
®
Defoamer Concen-
trate to the recovery tank. The amount needed will change
according to the amount of detergent already in the carpet.
CAUTION: Do not leave the extractor or other cleaning
machines or tools on the carpet when not in
use. Cleaning solution in the machines and
tools can leak onto the carpet and cause light
spots or stains.
NOTE: To order Clarkare
®
Extractor Concentrate, Order
Part No. 398421. To order Clarkare
®
Defoamer,
order Part No. 398420.
For instructions for preparation and operation of your floor tool, read
the operator's manual supplied with your floor tool.
To Next Page
Loading...
Need help?
General
