Model FLE Assembly Casing Assembly
750-192 3-17
10. Install Lift Lug Cover
• Using the insulation trimmed from step 8 (part 4), fill
the gap between the lift lug and the insulation.
• Pack any gaps in the insulation (Figure 3-34).
• Place a bead of silicone around the lug and on the
inside edge of the roof (Figure 3-35).
• Place the cover over the lug and silicone. If wedges
are being used, the cover should be tight to the side
opposite the lugs (ie. If the wedges are on the front of
the boiler, the cover should be tight to the rear of the
lift lug). Attach the cover so that the side tight
against the lug is screwed first (Figure 3-36).
• Use a putty knife and clean the surface of the cover
(Figure 3-37).
Figure 3-34. Filling the Gaps with Insulation
Figure 3-35. Silicone around the Lifting Lug
Figure 3-36. Screwing the cover tight to the Side
Opposite to the Wedges
Figure 3-37. Cleaning Excess Silicone from the Lid
To Next Page
Loading...
