50
• While holding the vehicle belt tight,
close both Rear-Facing Belt Lock-offs as
shown in Figure 66.
Check that the entire lap/shoulder belt (both
the lap and shoulder portions of the belt) or
lap belt (for lap-only belt installation) is under
both Rear-Facing Belt Lock-offs and under
both forward Belt Tabs.
Step 9
Check for secure installation. Gripping car
seat at top of armrests, pull car seat front
to back and left to right to check for secure
installation as shown in Figure 67. Vehicle
belt must stay tight and car seat should not
move more than 1 in. (2.5 cm) in
any direction.
• If vehicle belt still does not stay tight or
car seat cannot be securely installed,
try a different vehicle seat location
or install using LATCH, see “Installing
Rear-Facing Car Seat With LATCH” on
p a g e 3 7.
Figure 67
Figure 66
To Next Page
Loading...
