ClimateWorx M52 - Page 24

Advanced M52 Microprocessor User's Guide
ADVANCED M52UMCT2019 COLOR 23
Low S. Temp
High S. Humidity
Low S. Humidity
Loss of S. Sensor
High Voltage
Only show alarm
Low Voltage Only show alarm
Custom Fault 1
Custom Fault 2
Loss of EX1 Only show alarm
Loss of EX2 Only show alarm
F Drier dirty Only show alarm
Note:
1
All units in the same Co-Work network will shut down.
2
On DX units fitted with external motor
protector module only.
The following table summarizes the default configuration for all of the Common Alarm outputs for each
alarm. They are categorized in two different priorities Critical and Non Critical. This can be changed by
longing in with the level 1 password and touching the common alarm icon to change it’s state.
Alarm Message
Originates Default Configuration System Designation
Fan Fault Main Board Critical
Low Air Flow Main Board Critical
Humidifier Service Main Board
N
on Critical
Heater Overheat Main Board
N
on Critical
Filter dirty Main Board
N
on Critical
Fire Alarm/ Emergency Power Off Main Board Critical
Liquid Detection Main Board Critical
Liquid High Limit Main Board Critical
Power Phase Loss Main Board Critical
High pressure Comp. 1 EXP 1
N
on Critical
Low pressure Comp. 1
EXP 1
N
on Critical
Overload Comp. 1
EXP 1
N
on Critical
High pressure Comp. 2
EXP 2
N
on Critical