EasyManua.ls Logo

COBHAM EXPLORER 3075GX User Manual

COBHAM EXPLORER 3075GX
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EXPLORER 3075GX
Installation and user manual
Manual-Deploy Antenna System

Table of Contents

Other manuals for COBHAM EXPLORER 3075GX

Question and Answer IconNeed help?

Do you have a question about the COBHAM EXPLORER 3075GX and is the answer not in the manual?

COBHAM EXPLORER 3075GX Specifications

General IconGeneral
Frequency BandKu-band
Antenna Diameter75 cm
PolarizationLinear
Antenna TypeParabolic
TrackingAutomatic
Frequency Range (Tx)14.0 - 14.5 GHz
Frequency Range (Rx)10.7 to 12.75 GHz
Power Consumption60 W
Operating Temperature-25°C to +55°C
G/T12 dB/K
Elevation Range5° to 90°
Azimuth Range360°
Wind Survival100 knots
HumidityUp to 100%
Pointing Accuracy0.2° (Typical)

Summary

Safety and Regulatory Information

Safety Summary

General safety precautions, radiation, power, and environmental hazards.

Chapter 1: About this manual

Precautions

Important safety warnings, cautions, and notes for operating and maintaining the equipment.

Chapter 2: Introduction

Description of the system components

Detailed description of the system's major components like antenna positioner, RF assembly, electronics enclosure.

Chapter 3: Assembly & start up

To assemble the EXPLORER 3075GX

Step-by-step instructions for assembling the EXPLORER 3075GX system, including prerequisites.

Start up with manual acquisition

Procedure for powering up the system and acquiring a satellite signal using manual controls.

Chapter 4: Setup and operation

Setup using the web interface

Guide to configuring the system, network, and WLAN using the built-in web interface.

Chapter 5: Service

General support

Information on obtaining support, preventative maintenance, and diagnostics reports for the system.

Software update

Procedures for updating the system software for the EXPLORER 3075GX and GX modem.

Status signalling with LEDs and status messages

Explains system status indication through LEDs on the keypad and status messages in the display.

Appendix A: Technical specifications

Appendix B: System messages

Related product manuals