General support
98-144390-A Chapter 5: Service 5-7
8. The Unified Web Interface of the Core Module will indicate the modem in the network
as well as the modem status in the display in the menu MODEM.
9. When commissioning is completed, test all subscribed services.
5.1.6 LNB data update
If the RF assembly or the LNB has been replaced you must update the LNB data.
To enter data of the new LNB do as follows:
1. Select SERVICE > LNB.
2. Enter the new values:
LNB-LPN: LNB model number
LNB-LSN: LNB serial number, in Inmarsat format
L-MID: Manufacturer ID
LNB-FID: LNB function ID (typically empty, shown with a "-")
3. Click Apply to save the new settings.
4. Restart the system and wait for Net ok in the display.
5. If you have replaced the RF assembly, you must make a One Touch Commissioning, see
GX Modem: One Touch Commissioning on page 5-6.
WARNING! Make sure to enter the correct values for the new LNB.
Incorrect values may make the system inoperable.
Figure 5-9: Web interface: SERVICE > LNB
To Next Page
Loading...
Need help?
General