Setup using the web interface
4-8 Chapter 4: Setup and operation 98-144390-A
4.1.4 WLAN settings
On this page you can enable and set up the WLAN access point. Do as follows:
1. Select SETTINGS > WLAN from the left navigation pane.
2. Enable or disable the WLAN (default: Disabled).
3. Select the Country for your present location.
4. WLAN channel can be changed, channels available depend on the setting for
Country.
5. For Broadcast SSID, select Enabled (default) or Disabled.
Enabled: WLAN access point is shown to other users.
Disabled: WLAN access point is hidden.
6. Type in the SSID of your choice or accept the default SSID, which is Cobham. The
SSID is the name of the wireless local area network. It is a text with maximum 32
characters.
7. Select the Security standard. Select one of the following encryption standards:
• Disabled (default)
• WEP-64, enter the encryption key in hexadecimal format.
• WEP-128, enter the encryption key in hexadecimal format.
• WPA-PSK, enter the encryption key in hexadecimal or text format.
• WPA2-PSK, enter the encryption key in hexadecimal or text format.
8. Type in the Encryption key for the selected Security standard. This is not applicable if
you have selected Security mode None.
9. Click Apply.
Figure 4-6: Web interface: SETTINGS > WLAN
To Next Page
Loading...
Need help?
General