List of events
B-2 Appendix B: System messages 98-144390-A
B.2 List of events
Error code
(ID)
Severity Description Explanation
08065-0 ADM WARNING GNSS data Missing GPS data (fix).
08067-0 ADM ERROR PCB temperature ADM temperature too high. The ACU is not
equipped with a fan, so make sure there is
compliance with the environmental
specifications.
0806A-0 ADM WARNING VMU connection The ACU has lost connection with the sat
modem.
0806C-0 ADM ERROR VMU frequency setup There is a mismatch in the frequency setup.
Probably the sat modem is not configured
correctly to match the requirements of the
ACU and antenna. A common mismatch is
the absence of Rx or Tx LO parameter in the
VSAT modem.
0806E-0 ADM ERROR VMU 10 MHz reference The VMU Rx or Tx reference signal is not
present. Whether this error Rx or Tx
reference, depends on the users selection
on the modem profile page. Make sure VMU
Rx/Tx cable is connected and that the VMU
is configured to output the RX/TX reference
signal.
08078-0 ADM WARNING VMU TX frequency invalid VSAT modem unit provided a TX frequency
of zero. This may degrade tx performance.
To remove this warning re-configure the
modem to provide the correct tx frequency.
08104-0 ADM ERROR Antenna communication The ACU cannot communicate with the
antenna. Check cable and antenna.
08107-0 ADM ERROR ADM FPGA load The ADM FPGA cannot be initialised and
loaded.
0810A-0 ADM ERROR ADM production data Production data has been corrupted.
0810C-0 ADM ERROR File system integrity One or more file system partitions are
corrupt. You may have lost your settings
and collected statistics. If restarting the
system does not help, contact your service
partner.
Table B-1: Event messages
To Next Page
Loading...
Need help?
General