Setup using the web interface
4-12 Chapter 4: Setup and operation 98-144390-A
2. For each item under ALLOW USERS TO: select
• Yes to allow the guest user access
• No to block the guest user access to the settings. Then the pages are read-only,
changes cannot be made by the guest user.
Change network: Locks the page SETTINGS > Network. Use this page to change IP
configuration of the LAN connectors. For further information see To configure the LAN
network on page 4-6.
Modify LNB data: Locks the page SERVICE > LNB for guest users. This page is used
when exchanging an LNB.
Control Modem: Locks the page SERVICE > Modem for guest users. This page is used
to reset or power cycle the GX modem.
3. Click Apply.
4.1.8 Import and export of a system configuration
The configuration file contains all the settings you have entered during system setup:
satellite profiles, VSAT modem profiles, LAN setup, user permissions etc. If you need to
reuse a configuration in another EXPLORER 3075GX, you can save the current configuration
to a file, which can then be loaded into another EXPLORER 3075GX. You can also use this
feature for backup purposes.
To save a configuration to a file, do as follows:
1. Select ADMINISTRATION > Export/import config.
2. Click the button Export. Follow the download instructions on the screen. You can use
this configuration file for upload into another EXPLORER 3075GX,
Load and save configurations can only be done when the units have the same
software version.
The configuration file contains the encryption key of the WLAN.
Figure 4-12: Web interface: Administration, Export/import configuration
To Next Page
Loading...
Need help?
General