List of events
98-144390-A Appendix B: System messages B-3
0810D-0 ADM ERROR Antenna communication Link to the ACU could not be established.
Either the ACU is malfunctioning, or - if the
system software has just been updated - the
software is too old and is not compatible
with the ACU hardware.
08800-0 ADM ERROR Internal power supply An internal power supply voltage is outside
its legal range.
08840-0 ADM WARNING Master PLL lock The master PLL has lost lock. Check the
input reference signal.
08841-0 ADM ERROR Tuner lock The internal tuner PLL was unable to lock.
08842-0 ADM WARNING GSC demodulator The GSC demodulator has reported an error.
08843-0 ADM WARNING DVBS demodulator The DVBS demodulator cannot be initialised
and loaded correctly.
08844-0 ADM WARNING BUC voltage The BUC voltage is out of range.
08845-0 ADM WARNING LNB voltage The LNB voltage is out of range. The LNB
might be switched off to protect the power
supply circuitry. Reactivate satellite profile
to try again, check LNB cable and
surroundings if the problem persists.
08880-0 ADM ERROR WLAN configuration error Configuration of WLAN module failed.
08A00-0 ADM WARNING GX Core Module fan There is a problem with the Core Module
fan. Check/clean and replace if necessary.
08A01-0 ADM WARNING GX Core Module heater There is a problem with the Core Module
heater. Check and replace if necessary.
08A02-0 ADM WARNING GX Core Module temperature The Core Module temperature is out of
range. It may affect performance, and it will
be shut down if the situation gets worse.
08A03-0 ADM ERROR GX Core Module power The Power Good signal from the Core
Module is low. Check cables.
08A04-0 ADM WARNING iDirect modem The ACU detected a warning/error in the
iDirect modem. Log into the modem for
more information. Info:
0x00000001: Temperature error
0x00000002: Test error
0x00000004: Fan error
Error code
(ID)
Severity Description Explanation
Table B-1: Event messages (Continued)
To Next Page
Loading...
Need help?
General