Chapter 4: To use the web interface
98-140012-H Advanced settings 93
To change the administrator password
To change the administrator password, do as follows:
1. Log in as administrator
2. Under Advanced, select Passwords > Change administrator password.
3. Type in the Old password.
4. Type in the New password and retype it on the next line.
5. Click Save.
At the next login the new password is required.
To log out as administrator
If you have not entered anything for 30 minutes under Advanced, you are logged out
automatically. To log out manually, click Logout administrator in the Advanced page or
click [log out] next to administrator in the Terminal status field.
To set up user permissions
You can allow or deny users access to certain functions and make these pages read-only. This is
useful if you want to protect the system against unintended changes. Study this screen
thoroughly and decide to which areas of the system you want to give non-administrator users
access. To set up the user permissions, do as follows:
1. Under Advanced, select User permissions.
2. Under Allow users to:, select the settings you want to allow users to access.
3. Under Allow user accounts:, select Service user account if you want to enable the
use of a service user account.
4. Click Save.
The settings without a check mark can only be viewed but not changed by the non-
administrator user.
If you remove the check mark at one of the interface settings (LAN, WLAN etc.), it
will not be possible to enable/disable the interface from the display.
To Next Page
Loading...
