COBHAM Explorer 710 - To Set Up Tracking and Location Reporting

Chapter 4: To use the web interface
98-140012-H To set up your data connection packages 79
To set up your data connection packages
There are different types of connection packages for different purposes:
• Shared connection, see To create a shared connection package on page 83.
This is a shared data connection package, which may include different connections (PDP
contexts) for different types of traffic. For the predefined Standard connection package,
ACA is disabled, but can be enabled. For new connection packages, ACA is disabled and
cannot be enabled for shared connections.
• Dedicated connection, see To set up dedicated connections on page 87.
This is a connection dedicated specifically to each unit connected to the EXPLORER 710.
Connection packages
Note
You must be logged in as administrator in order to change, delete or create
connection packages.
If you want to Do as follows
Run one connection at a
time from the startup
page.
This is the default setup, with only one connection in each
connection package.
Start the connection you need from the web interface or the
display.
Use different connection
types for different types
of traffic.
Add more connections to a connection package and apply filters
to assign different connection types to different types of traffic.
See Multiple data connections on page 82.
Start all the connections in the package by starting the package
from the web interface or the display.
Extend your bandwidth
by connecting two
EXPLORER 710 terminals
(bonding).
Set up two EXPLORER 710 terminals as described in To set up
channel bonding on page 77 and Bonding of terminals on
page 33.
Start the bonding connection package from the web interface or
the display (typically named 2 * <connection type>).