COBHAM Explorer 710 - Tracking and Location Reporting

Chapter 3: To use the EXPLORER 710
98-140012-H To see properties of the EXPLORER 710 in the display 47
To change the language in the display
The default language of the display is English. You can change the language to French,
German, Russian, Spanish, Chinese or Japanese.
1. From the display menu, select Settings > Language.
2. Select the language you want.
To see properties of the EXPLORER 710 in the display
Using the display and keypad, you can see properties of the EXPLORER 710. Do as follows:
1. From the display menu, select Properties.
2. Select IP address to see the local IP address of the EXPLORER 710.
3. Select Hardware to see serial numbers and MAC addresses for the EXPLORER 710.
4. Select Software to see the software version of the EXPLORER 710.
5. Select Conformity to see a list of the standards to which the EXPLORER 710 conforms.
6. Select IMEI to see the IMEI number of the EXPLORER 710.
Tracking and location reporting
The EXPLORER 710 can be used for tracking purposes. You can set up the terminal to report its
position to a server at certain time intervals.
To use the tracking feature you must either set up a tracking server or get a tracking solution
from your service provider. The EXPLORER 710 must be set up to match this server. For
information how to set up the EXPLORER 710, see To set up tracking and location reporting
on page 88. Once set up on both sides, the EXPLORER 710 will send position reports to the
server as specified.
Note
HDR streaming is not available when you are using the Tracking function.