COBHAM Explorer 710 - Page 154

Appendix B: Command reference
98-140012-H SMS remote commands 145
SMS remote commands
This section describes syntax and parameters for the SMS commands. For examples of use, see
Remote access with SMS on page 37
Syntax conventions
Syntax definitions use the following conventions:
• <parm> indicates that a parameter (without < and >) can be filled in by the user.
• { <opt1> | <opt2> | … | NA } indicates that one of various options must be chosen by the user.
Use NA when no value is defined.
• Keywords and parameters are separated by the space (ASCII 32) character.
• The command name and all keywords must be in upper case; most user-provided
parameters are case sensitive but may be either case.
• TE means Terminal Equipment - the equipment connected locally to the EXPLORER 710.
SMS remote command summary
Commands
The table below summarizes the available SMS remote commands. The password comes just
after the last parameter (except for the ATCO command, see below). For examples, see
Remote access with SMS on page 29.
Command Parameters Password
ACTIVATE <qos> <PC/TE type> <apn> <user> <pwd> <rsms_pwd>
ADPWRST 1 <imei> <rsms_pwd>
ADVWATCHDOG <get/set> <wdog_enable> <wakeup> <interval> <ping1> <ping2> <ping3>
<apn_type> <apn> <user> <pwd> <pos_response> <sms_number>
<rsms_pwd>
CLEAR <category> SMS <rsms_pwd>
DEACTIVATE <qos> <PC/TE type> <rsms_pwd>
GETINFO <info_mode> <dataset> <rsms_pwd>
RESTART <reset_type> BGAN <rsms_pwd>
WATCHDOG <wdog_op> <ping1> <ping2> <ping3> <ping_always> <ping_interval>
<wdog_enable>
<rsms_pwd>
WANMODE <cmd_op> {<wanmode>} <rsms_pwd>
SMS command for sending AT commands
ATCO <resp_mode> <rsms_pwd> <at_cmd>