Chapter 3: To use the EXPLORER 710
98-140012-H Phone connection 43
If there was an error establishing the connection, the web interface and the display of the
EXPLORER 710 show an error message.
To receive a call
By default, all devices connected to the EXPLORER 710 will ring when one of the mobile
numbers is called. Note however, that this depends on the call type settings. See Call types on
page 42.
Information on missed calls is stored in the call log. You can see the call log in the web
interface (Control panel
> Logs > Call log).
To make a call to the EXPLORER 710
To make a call to a phone connected to the EXPLORER 710, dial + <Mobile number>
• + is the prefix used in front of the country code for international calls. This is 00 when
calling from countries in Europe and from many other countries.
• Mobile number. The first part of the mobile number is always 870, which is the “country
code” for the BGAN system. For information on the mobile numbers, refer to your airtime
subscription.
There are two mobile numbers, one for 3.1 kHz audio and one for Standard
voice.
To Next Page
Loading...
