Chapter 4: To use the web interface
98-140012-H Support features 72
To reset the administrator password
If you have forgotten the administrator password, do as follows:
1. Contact your supplier for a reset code.
Report the serial number and IMEI number of the terminal.
You can find the serial number and IMEI number in the display on the terminal by selecting
the menu
and then Properties.
2. After receiving the reset code from your supplier, select Reset password from the
Support page.
3. Type in the reset code obtained from your supplier and click Reset.
4. The password is disabled.
You now have access to all settings. If you want to use a password, enable the password as
described in To disable the administrator password on page 92.
To restart the terminal
If you want to restart the terminal, do as follows:
1. From the Support page, select Reboot terminal.
2. Click to confirm the reboot.
The terminal restarts. Note that this is the equivalent to switching the terminal off and on
again.
About
The About page shows the Serial number, IMSI number, IMEI number and software
version of your EXPLORER 710. It also shows your Help desk information, if it has been
entered under Advanced > Help desk.
To access the About page, select Support > About.
To Next Page
Loading...
