MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Date: 28-Jan-16 Cobham Wireless – Coverage
Page | VI
Rev. 2.1 Doc. No. 00046UM
Unauthorized Changes to Equipment
Changes or Modifications not expressly approved by the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.
Only for in-building applications
Use only for in-building applications in sites located in regions that require FCC compliance.
One must be aware that FCC regulation mandates that this repeater is to be used only
for in-building
applications and thus feed passive or active DAS (Distributed Antenna Systems) accordingly.
FCC RF Exposure Limits
This unit complies with FCC RF exposure limits for an uncontrolled environment. This equipment must be
installed and operated with a minimum distance of 36cm between the radiator and any person’s body.
Antenna Installation
Installation of an antenna must comply with the FCC & IC RF exposure requirements. The antenna used for this
booster must be mounted on outdoor or indoor permanent structures.
For Public Safety SMR700/SMR800 devices: The MPE (Maximum Permissible Exposure) value of the MBF
40, when correctly installed, meets the applicable power density RF exposure limit for an uncontrolled
environment at a minimum safe operating distance of 36cm. This is achieved using an external antenna having
a maximum gain of 16.14dBi with 3 dB minimum cable loss and 11dB minimum internal attenuation, or an
internal antenna having a maximum gain of 4.14dBi with 2dB minimum cable loss. Internal or external antennas
having gains higher than those stated above should not be used.
Antennas having a gain greater than these are strictly prohibited for use with this device.
To Next Page
Loading...
General