MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Date: 28-Jan-16 Cobham Wireless – Coverage
Page | 50
Rev. 2.1 Doc. No. 00046UM
To activate the MBF-40 SNMP Agent
1. Click on the Config button (top right corner) and select SNMP Agent Config. The following
pane appears:
2. Set the SNMP Agent toggle to ON.
3. Set the port and the Read-Only community.
4. Click Apply.
4.5 User Accounts
The MBF-40 comes pre-configured with default usernames and passwords in the various
administration levels.
At the moment, updating user accounts is available only via Command Line Interface (CLI) or Axell
Shell. See the Common Commands and Attributes v2.4.0 document for detailed commands and
syntax or click on the Help button at the top right of the Web-GUI screen.
4.5.1 Default User Accounts
User
Name
Default Password Details
Axell AxellPasswd Default user name.
omcuname iwnkhoob Element Manager (AEM) user account. This account will not
generate VLI, LGO or CLR alarms.
sysadmin AxellAdmin4050 This is the system administration password which is used for
firmware upgrades and user administration. Escalation to this
level is achieved by issuing command SYSADMIN from the
user prompt.
useradmin UseradminPwd23
Escalation to this level is achieved by issuing command
USERADMIN from the user prompt.
NOTE: It is strongly recommended to change the default user names and passwords immediately at
commissioning. This is done by using the command ACT PASSWORD. Please refer to the User Administration
section in Common Commands and Attributes document for detailed syntax.