WARNING: This product is a booster and it is the responsibility of the licensee / installer to select
the correct cabling and antennas for their particular deployment scenario.
FCC Part 90 Warning Statement
WARNING: This is NOT a CONSUMER device. This device is designed for installation by FCC
LICENCEES and QUALIFIED INSTALLERS. You must have an FCC LICENCE or express consent of
an FCC Licensee to operate this device.
This is a Class B signal booster. You MUST register Class B signal boosters (as defined in 47 CFR
90.219) online at www.fcc.gov/signal-boosters/registration.
Unauthorized use may result in significant forfeiture penalties, including penalties in excess of
$100,000 for each continuing violation.
The installation procedure must result in the signal booster complying with FCC requirements
90.219(d). In order to meet FCC requirements 90.219(d), it may be necessary for the installer to
reduce the UL and/or DL output power for certain installations.
FCC Part 15
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
A. This device may not cause harmful interference, and
B. This device must accept any interference received, including interference that may cause undesired
operation.
If not installed and used in accordance with the instructions, this equipment generates, uses and can radiate
radio frequency energy. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to RF reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
To Next Page
Loading...
General