MBF-40 SMR700/SMR800 PS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 28-Jan-16 www.cobham.com/wireless
Doc. No. 00046UM Rev. 2.1
Page | IX
Attention: Electrostatic
Sensitivity
o Observe electrostatic precautionary procedures.
o ESD = Electrostatic Discharge Sensitive Device.
o Static electricity can be conducted to the semiconductor chip from the
centre pin of the RF input connector, and through the AC connector pins.
When unpacking and otherwise handling the repeater, follow ESD
precautionary procedures including use of grounded wrist straps,
grounded workbench surfaces, and grounded floor mats.
Caution: Class 1 Laser
The repeaters described in this manual are equipped with class 1 lasers, as per
definition in EN 60825-1
Caution - Un-terminated optical receptacles may emit laser radiation. Exercise
caution as follows:
o Do not stare into beam or view with optical instruments. Optical
transmitters in the Fiber optic converter can send out high energy invisible
laser radiation. There is a risk for permanent damage to the eye.
o Always use protective cover on all cables and connectors which are not
connected.
o Never look directly into a Fiber cable or a connector.
o Consider that a Fiber can carry transmission in both directions.
o During handling of laser cables or connections, ensure that the source is
switched off.
o Regard all open connectors with respect and direct them in a safe
direction and never towards a reflecting surface. Reflected laser radiation
should be regarded as equally hazardous as direct radiation.
To Next Page
Loading...
General