Introduction to the web interface
98-175666-D Chapter 3: Setup of the antenna 3-4
Sections on the Dashboard
Parameter Description
ANTENNA
VSAT profile Name of the currently active VSAT profile
Satellite position Longitude position of the satellite
RX polarization LHCP or RHCP, auto-selected by the modem
TX polarization Co-pol or X-pol, auto-selected by the modem
RX RF frequency Receiving transponder frequency
LNB LO frequency Block-down Local Oscillator, auto-selected by the modem
TX RF frequency Modem transmit frequency
BUC LO frequency Block-Down Local Oscillator, depending on antenna hardware
Tracking RF
frequency
Antenna tracking frequency
MODEM
Model VSAT modem model used with the currently active VSAT profile
RX locked status Shows whether the modem is in lock with the hub
Status Status information received from modem. Not available for all models.
Signal level RSSI information from the modem. Depending on the modem type, the
signal level can be the measured signal strength in mV or the reported
RSSI value in dB.
Reference Shows the BUC and LNB reference source
RX IF frequency Shows the L-band RX frequency selected by the modem
TX IF frequency Shows the L-band TX frequency used by the modem
TX allowed On or Off. Indicates if the modem supplies BUC reference signal on its TX
connector and if the modem indicates Rx locked and Tx ON (e.g.
OpenAMIP message L (L 1 1).
Table 3-1: Sections and parameters on the Dashboard
To Next Page
Loading...
Need help?
General
