Settings
98-175666-D Chapter 3: Setup of the antenna 3-22
3.2.8 IoT & management
On this page you can set up e-mail, remote syslog, SNMP, diagnostics and statistics
reporting, and IoT.
E-mail setup (secure e-mail)
To send e-mails from the antenna you must set up some parameters.
SMTP port numbers:
• Insecure Simple Mail Transfer Protocol: SMTP port number 25.
• SMTPS for secure Simple Mail Transfer Protocol: IP port 465.
• STARTTLS to upgrade SMTP to Secure Socket Layer (SSL) or Transport Layer
Security (TLS): IP port 587.
Contact your IT department for the specific data. To set up e-mail, do the following:
1. Go to Settings > E-mail setup.
2. Enter the data for Outgoing mail server (SMTP) and SMTP port number.
SMTP: SMTP over port 25
SMTPS: SMTP SSL/TLS encrypted over port 465.
STARTTLS: SMTP with STARTTLS upgrading to encrypted over port 587.
3. Select SMTP type.
4. Select SMTP authentication. If you have selected Credentials, you must specify a
User name and password. This data is typically provided by your IT department.
Figure 3-17: Settings, IoT & management (example)
Note
You must set Outgoing mail server to an IP address if DNS has not been set
up in DNS setup in Network settings on page 3-10.
To Next Page
Loading...
Need help?
General
