Setting up and operating the BUC system
68 Block Up Converter Systems 6700/6900 series User Guide
Set burst
mode power
threshold
Sets the burst mode power
threshold in dBm.
SBTn n = value within the
allowable threshold range
for your BUC
n = 0, disables burst
detection
NOTE
When you set a
new burst mode
power threshold,
the current,
minimum and
maximum burst
power readings
are reset to zero
(see page 72,
Output burst
powers).
You can set the threshold
level above which
transmitted TDMA bursts or
similar signals are recorded.
The allowable threshold
range depends upon the
model of the BUC. Use VLD
to display the upper and
lower limits of the allowable
range for your BUC (see
page 73, View limit data).
Table 14: Set commands (cont.)
Command Function Enter... Data required
To Next Page
Loading...
Need help?
General
