Codan 8528 Series - Page 103

Using the receiver in scan mode
Outback HF Radiophone 6-17
Step Action… Display shows… Remarks…
4.
To pause the scan,
press any of the
fast or slow Tune
Rx Frequency
buttons. Example:
1
Fast
The display shows the
channel number and the
current frequency.
You may move between
the frequencies by using
any of the Tune Rx
Frequency buttons.
5.
To resume
scanning, press
Scan
The display shows the
channel number and all
the frequencies as the
band is scanned
continuously.
The rate of scan will be
determined by whether
you pressed the fast or
slow button in step 3.
6.
To stop scanning,
press
Scan
The Scan button
indicator will go out.
7.
To recommence
normal scanning,
select another
non-band
scanning channel
and press
Scan
Refer to section 4,
Selecting channels.
q