Using selective call
Outback HF Radiophone 5-17
Receiving a selective call
Your Radiophone automatically completes the following event when receiving a
selective call.
Step Action… Display shows… Remarks…
1.
No action, the
Radiophone
automatically
completes this
event.
When you receive a call
the display changes to
show you the self-
identification address of
the calling station.
When you receive a call,
tones will be heard on the
loudspeaker.
You will hear a series of
three telephone rings for
selective calls, and 16
short ’beeps’ for group
calls.
Notes: On receipt of a call you have two options:
• either answer it immediately, refer to Answering a received call on
page 5-19
• let the Radiophone automatically store the callers self identification
number in memory to await your reply, refer to Returning a received
call–general on page 5-20.
If your Radiophone was unattended at the time the selective call was
received, the callers self identification number is stored in memory for
you to review at a later time. Refer to Reviewing the list of received calls
in memory on page 5-21.
If you do not answer the call immediately, once the call is stored in
memory your Radiophone will continue to give out ’pips’ every four
seconds to indicate that a call has been received. If you wish to silence
these ’pips’, yet still retain the display, press the Select Channel button.
If you only wish to receive selective calls, ensure the S’Call Mute button
is operated and the indicator lit.
F
To Next Page
Loading...
Need help?
General
