Codan 8528 Series - Setting the Pre-Amble Time Period

Using selective call
Outback HF Radiophone 5-5
Setting the pre-amble time period
1.
Ensure your
Radiophone is
switched off.
2.
Hold down
Call
Selective
and press
On/Off
Hold the Selective Call
button down for
approximately three
seconds.
This turns the
Radiophone on and into
the preamble set-up
mode.
3.
Press any of the
numeric buttons
to set the
preamble length.
or
Pressing any of the
numeric buttons
alternates between a long
or short preamble.
4.
Press
Enter
Once enter has been
pressed, the pre-amble
time has been set and can
only be changed by
repeating this procedure.
F
Step Action… Display shows… Remarks…