RFDS and Telstra services
10-8 Outback HF Radiophone
Step Action… Display shows… Remarks…
2.
Press
S’Call
OTC
and then press
Channel
Select
until the required
selective call
address appears
against the Telstra
station selected.
A table of all the Telstra
station selcall address
numbers is shown on
page 10-9.
3.
Press
S’Call
OTC
The display returns to
normal.
The selective call signal
is transmitted.
If the call is successful,
the Telstra station will
automatically respond
with a series of short
tones. The station
operator will then
respond with normal
voice communication.
4.
Use the
microphone to
carry out normal
voice
communication.
Refer to section 4, Using
the microphone.
F
To Next Page
Loading...
