Codan 8528 Series - Page 67

Using selective call
Outback HF Radiophone 5-15
Step Action… Display shows… Remarks…
4.
If your
Radiophone has
the fixed called
address, press
twice in
succession
Call
Selective
This is an example of the
called address
identification number
1374.
If the called address had
been programmed, as
described on page 5-6,
then the permanent
address will be
displayed.
The Tx indicator will be
lit and you will hear a
’warbling’ sound for
approximately 10
seconds.
Proceed to step 8.
5.
If your
Radiophone does
not have the fixed
called address
programmed,
press
Call
Selective
If the display shows the
correct address, proceed
to step 7.
If no address, or an
incorrect address is
shown, continue with
step 6.
6.
Use the numeric
buttons to enter
the required
selective call
address number.
F