31 | P a g e
Chapter 4 Common Parameters and Color-Changing Order
In this system each pattern has its own settings of the normal parameters (like scale and repetition) and
color-changing order. When a new pattern is selected, the corresponding settings of normal parameters and
color-changing order will become effective.
In this chapter, we will discuss the setting of the most frequently used parameters and color-changing order,
in parameter setting interface ( ) and needle bar color-changing order setting interface ( ).
Since this system supports multi-task operation, user can set and modify the normal parameters and color-
changing order of the patterns that are not embroidered at present. User can enter these operations via other
operation interface under pattern management (see Chapter 6).
4.1 Settings of Common Parameters
These common parameters include: “Direction”, “Angle”, “Scale X/Y”, “Prior Mode”, “Rep. Mode”, “Rep.
Order”, “Rep. Times”, and “Rep. Interval”. User can control the final embroidery results by adjusting these
parameters.
Press to enter parameter setting interface:
The way for setting the parameter is similar to each other. This chapter will explain how to set the “X/Y
Scale” as an example and give the definitions of other parameters (refer to 4.1.1 for setting method).
To Next Page
Loading...