COMAC CAL FLOW 38 Installation And Technical Manual

Technical and instalation
manual FLOW 38 Batch Page 36 (of 49) COMAC CAL
s.r.o.
Language
If you want to change the meter's language, press E and then select a desired language from menu.
Counter resetting
Here, it is possible to reset all or only certain volumetric counters. If you want to perform resetting,
press E and select which counter you wish to reset (∑V,-V, +V or all). After resetting, the date when
the last reset was performed is displayed and which counter was reset (again, ∑V,-V, +V or all).
Nominal diameter (DN)
This parameter is set in the factory and cannot be changed. DN modification can only be carried
out by an authorized person under production password.
Flow direction
Specifies the direction of flow in the flow sensor with respect to the data in electronics. Positive
direction is the flow in the sensor identical to the arrow indicated on the meter's name plate. If the
medium flows through the sensor against the arrow on the sensor, select the NEGATIVE direction.
If you wish to make the change, press E.
cz – Czech
de – German
en – English
pl – Polish
fr – French
es - Spanish

COMAC CAL FLOW 38 Specifications

General

Brand	COMAC CAL
Model	FLOW 38
Category	Measuring Instruments
Language	English