Technical and instalation
manual FLOW 38 Batch Page 49 (of 49) COMAC CAL
s.r.o.
Form for shipment of the meter back to COMAC CAL s.r.o.
The meter you have was made with the maximum precision and it has been checked many times and
wet calibrated.
If the meter is used in agreement with this manual, the occurrence of faults is very rare. Should they
ever occur, contact our service department. If you return the meter to the manufacturing plant, adhere
to the conditions stated below:
- Clear the meter of contaminations stuck to the sensor and measuring tube (eventually to the
Evaluation Unit).
- If the meter was run with poisonous, etching, combustible liquids or with fluids dangerous
to water, check it and if appropriate, flush and neutralize the cavities inside the sensor.
Fill in the following data please and the form duly completed attach to your consignment. COMAC
CAL s.r.o. will not be able to process your request promptly and correctly without this form.
Customer
Company……………………………… City……………………………
Department…………………………... Name……………………………
Phone no.…………………………….
Enclosed meter
Type………………………………… Serial number………………………….
Measured liquid…………………………………….
Description of a fault or modifications required………………………………………………
…………………………………………………………………………………………………………
…………………………………………………………………………………………………………
…………………………………………………………………………………………………………
…………………………………………………………………………
We confirm that the meter was duly cleaned, and if required, it was flushed out and neutralized.
Therefore, this consignment does not constitute any risk to humans and environment due to remnants
of the measured fluid.
Date……………………….. Signature and stamp……………………….
To Previous Page
Loading...
Need help?
General