Technical and instalation
manual FLOW 38 Batch Page 6 (of 49) COMAC CAL s.r.o.
Storage conditions
The temperature during transportation and storage of the meter must be within the range of -10 °C to
50 °C.
Wooden boards installed on the flanges in the factory are used for protection of lining on the flanges
during storage and transportation (for PTFE lining). Remove these protective boards just before
installing in the pipeline!!!
Do not lift the flanged meters by the transducer head or by the connecting box of the detached design
during transportation! Use slings and place them round both process connections for transportation of
meters up to DN125 (chains may damage the meter head)! Use only the metallic lugs on the flange for
transportation, lifting and installation of the sensor in piping in case of DN150 and bigger!!!
Warranty
Unprofessional installation or using the induction meters (devices) may result in a loss of warranty as
well as failure to comply with installation or operating conditions according to this manual.
In case of returning the meters for inspection or repair to the COMAC CAL s.r.o. factory, enclose
please the completed form, see the last page of this manual. Without having one, we will not be able
to handle your requirement for modification or possibly repair your meter correctly and promptly.
To Next Page
Loading...
Need help?
General