WARNING: Danger of gas exhalation and leakage of corrosive liquids.
WARNING: Danger of fire: do not go near with free flames
14. BATTERY CHARGER CONNECTION (VERSIONS WITH BC)
In order not to cause permanent damage to the batteries, it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of the "discharged batteries" blinking light.
WARNING: Never leave the batteries completely discharged, even if the
machine is not being used. Check the battery charger is suitable for the
batteries installed, in terms of both capacity and type.
To connect the battery charger you must:
1. Move the machine near to the battery charger
2. Check the key switch is on “0”; if this is not the case, turn the key of the main switch anticlockwise to “0”
3. Press the button (1) to release and rotate the recovery tank
4. Grip the recovery tank and rotate it until the gas spring (2) is resting on the solution tank
WARNING: This process must be carried out by qualified personnel. An
incorrect connection of the connector may cause problems with machine
functioning.
5. Connect the battery charger cable to the socket on the charger itself
6. Plug the battery charger cable into the mains socket.
The battery charger power cable is delivered inside the bag containing this instruction booklet.
WARNING: Carefully read the use and maintenance manual of the charger
that is delivered inside the bag containing this instruction booklet.
WARNING: Before inserting the charger power cable into the socket, verify
that there is no condensate or other forms of liquids.
WARNING: if the machine's electric system is accidentally powered (by
turning the main switch to ON), the commands display will show “BATTERY-
CHARGER” and no steering wheel command will function.
15. BATTERY CHARGE LEVEL INDICATO
On the instrument panel of the machine there is a monitor (1) indicating (amongst other things) the battery
charge status. If the lower line contains ten light indicators, the battery charge level is 100%. If the battery
charge percentage is at 00% and flashing, this means the batteries are discharged.
To Next Page
Loading...
