WARNING: a few seconds after the battery charge level reaches 20%, the brush
motor switches off automatically. With the remaining charge it is still possible,
however, to complete the drying process before recharging
WARNING: a few seconds after the battery charge level reaches 10%, the vacuum
motor switches off automatically. With the remaining charge, it is still possible,
however, to move the machine to the location designated for its recharging
16. HOUR METER
On the machine's instrument panel there is a display (1) indicating the total machine usage time. The top
line shows the hours and minutes of functioning. The flashing “:” symbol Indicates that the hour meter is
counting the machine functioning time.
17. FORWARD WORK SPEED
This machine is equipped with electronic traction control. To move the machine, turn the key to “I” then
press the drive pedal (1), adjusting the speed by altering the degree of pressure on the pedal.
ATTENTION! The machine will not start to move (either forwards or backwards) if the
electrical brake is not engaged. In this case, you will see "ELECTRICAL BRAKE?" on
the command display.
To move the machine backwards, press the button (2) on the instrument panel, then immediately press the
pedal (1). Adjust the speed by altering the degree of pressure on the pedal.
WARNING! The reverse speed is lower than the forward speed to comply with current
health and safety standards.
ATTENTION! The machine will not start to move in reverse if the squeegee is lowered.
18. SOLUTION TANK
The recovery tank must be completely empty each time the solution tank is filled.
Remove the inlet cap (1) located on the left side of the machine.
WARNING: The recovery tank must be completely empty each time the
solution tank is filled.
Check that the solution filter cap (2), under the solution tank in the front right of the machine, is properly
closed.
Check that the solution tank drainage tap (3) (under the solution tank in the right part of the brush head
body) is well closed.
To Next Page
Loading...
