37
PERFORMANCE
PERFORMANCEPERFORMANCE
PERFORMANCE
SETTING FOR WORK
SETTING FOR WORKSETTING FOR WORK
SETTING FOR WORK
1.
Connect the connector (1) to the batteries
1
2. Turn the key of the general switch (2) into position “1” (clockwise). Immediately, the
signal lamp comes on (3).
3.
Press the solenoid valve switch (4)
4.
Press the suction motor switch (5)
5.
Press the brush switch (6)
6
5
4
3
2
6. Acting upon the cock lever (1) adjust the quantity of the detergent solution which has
to be sufficient to wet the floor uniformly but not too much to get out of the
splashguard. Please keep in mind that, the correct solution quantity depends always
on the type of floor, the dirt and the speed.
7.
Release the lever (2) and lower the brush base
8.
Lower the squeegee acting upon the lever (3)
9.
Check that the parking brake (4) is released
1
4
3
2
10. Pushing forward the lever (1) on the handle bar, the machine begins to move. During
the first metres of operating, check that the quantity of the detergent solution is
sufficient and that the squeegee dries perfectly.
The machine will now start working efficiently until the detergent solution runs out.
1
To Next Page
Loading...
