COMAC Simpla - End of Work Procedures; Pre-Maintenance Shutdown Steps; Recovery Tank Emptying; Brush Removal and Cleaning

40
ON COMPLETION OF THE WORK
ON COMPLETION OF THE WORKON COMPLETION OF THE WORK
ON COMPLETION OF THE WORK
Having finished the job and before any type of maintenance is done:
1.
Close the cock through the lever (1)
2.
Raise the brush base through the lever (2)
3.
Raise the squeegee through the lever (3)
1
3
2
4. Switch off the solenoid valve switch (1)
5.
Switch off the brush switch (2)
6.
Switch off the suction motor switch (3)
7.
Bring the machine up to the place provided for the water outlet
8.
Turn the key (4) into position “0” (counterclockwise)
9.
Insert the parking brake
2
3
1
4
10. Extract the hose placed on the front part of the recovery tank
11.
Unscrew the exhaust plug and empty the tank
WARNING!
WARNING! WARNING!
WARNING! This operation has to be carried out using gloves
to protect from contact with dangerous solutions.
12.
Take off the brush and clean it with a water jet (for the brush
disassembly please read further on under “DISASSEMBLY OF THE
BRUSH”)