45
TROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDETROUBLE SHOOTING GUIDE
TROUBLE SHOOTING GUIDE
INSUFFICIENT WATER ONTO THE BRUSH
INSUFFICIENT WATER ONTO THE BRUSHINSUFFICIENT WATER ONTO THE BRUSH
INSUFFICIENT WATER ONTO THE BRUSH
1.
Make sure that the cock (1) is open
2.
That there is water in the solution tank
3.
Make sure that the solenoid valve switch is on
1
THE MACHINE DOES NOT CLEAN SATISFACTORILY
THE MACHINE DOES NOT CLEAN SATISFACTORILYTHE MACHINE DOES NOT CLEAN SATISFACTORILY
THE MACHINE DOES NOT CLEAN SATISFACTORILY
1.
Check the condition of the brush and replace it, if necessary (the brush has to be
replaced when the bristles reach around 15mm)
2.
Use a different kind of brush to the one fitted as standard. For cleaning operations on
floors where the dirt proves to be particularly resistant, we recommend using special
brushes that may be supplied optionally according to needs (see under “CHOICE
AND USE OF BRUSHES”).
THE SQUEEGEE DOES NOT DRY PERFECTLY
THE SQUEEGEE DOES NOT DRY PERFECTLYTHE SQUEEGEE DOES NOT DRY PERFECTLY
THE SQUEEGEE DOES NOT DRY PERFECTLY
1.
Check that the squeegee rubbers are clean
2.
Adjust the inclination of the squeegee (see under “SQUEEGEE” in “MACHINE
PREPARATION”)
3.
Check that the suction hose is correctly fitted in its housing on the recovery tank
4.
Take off the entire suction assembly and clean it
5.
Replace the rubbers, if worn
6.
Check that the suction motor switch is on
7.
Check the adjustment of the wheels
EXCESSIVE FOAM PRODUCTION
EXCESSIVE FOAM PRODUCTIONEXCESSIVE FOAM PRODUCTION
EXCESSIVE FOAM PRODUCTION
Check that a low foam detergent has been used. If required, add a small quantity of
antifoam liquid into the recovery tank.
Remember that, when the floor is not very dirty, more foam is generated. In this case
dilute more the detergent.
To Next Page
Loading...
