38
PERFORMANCE
PERFORMANCEPERFORMANCE
PERFORMANCE
Whenever problems during operating should arise, release the lever and
push immediately the emergency brake placed on the left side. This
command will block the traction of the machine. To restart the machine
again, once the problem has been solved, release the lever of the parking
brake and push forward the lever on the handle bar.
DEVICE TOO FULL
DEVICE TOO FULLDEVICE TOO FULL
DEVICE TOO FULL
The machine is equipped with a float, which intervenes when the recovery
tank is full causing the closure of the suction hose. In this case, it is
necessary to proceed with the emptying of the recovery tank taking off the
plug of the exhaust pipe.
WARNING!
WARNING! WARNING!
WARNING! This operation has to be carried out using gloves
to protect from contact with dangerous solutions
.
MOVEMENT (machines without traction)
MOVEMENT (machines without traction)MOVEMENT (machines without traction)
MOVEMENT (machines without traction)
The traction of these machines is obtained through the brush, which works
slightly inclined, so that the machine is being dragged forward. To move the
machine, it is necessary to act upon the key (1), wait for 3 seconds and
then rotate forward (forward movement) the lever (2) on the handle bar.
WARNING!
WARNING! WARNING!
WARNING! When carrying out even short backward
movements, make sure that the squeegee is lifted
.
2
1
To Next Page
Loading...
