InteliLite Global Guide
280
Setpoint group Scheduler Related FW 1.2.1
Range [units]
Disabled / 1.. Rental Timer 1 (page 278) [h]
Default value Disabled Alternative config NO
Step 1 h
Comm object 14332 Related applications AMF, MRS
Config level Advanced
Setpoint visibility
Conditioned by the setpoint Rental Timer 1 (page 278)
Description
Alarm Wrn Rental Timer 1 (page 575) comes up after xx running hours from adjusting the Rental Timer 1
(page 278). Hours are adjusted by this setpoint.
Image 8.61 Rental Timer 1 Wrn
Rental Timer 1 Wrn
6 back to List of setpoints
Setpoint group Scheduler Related FW 1.2.1
Range [units] [DD/MM/YYYY]
Default value 01/01/2015 Alternative config NO
Step 1 day
Comm object 14367 Related applications AMF, MRS
Config level Advanced
Setpoint visibility Always
Description
Another engine start is not allowed when this timer elapsed. This timer is based on date. At the midnight of
the last day the alarm Rental Timer 2 Elapsed (page 566) will be recorded in alarm list and the binary
output AL RENTAL TIMER 2 (PAGE 475) will close.
IMPORTANT: To reset Rental Timer 2 (page 280) we have to set up Rental Timer 2 (page 280)
again. It means go to setpoint group Scheduler and to the setpoint Rental Timer 2 (page 280).
Then press enter button , change the value if it is necessary and press enter button
again.
IMPORTANT: To disable Rental Timer 2 (page 280) set date to 01/01/2015.
Rental Timer 2
To Next Page
Loading...
Need help?
General
