To Next Page

To Previous Page

InteliLite Global Guide

283

Group: Geo-Fencing

Setpoint group CM-4G-GPS Related FW 1.2.1

Range [units] -90,0000..90,0000 [°]

Default value 0,0000 ° Alternative config NO

Step 0,0001 °

Comm object 14606 Related applications AMF, MRS

Config level Standard

Setpoint visibility Only if relevant module is installed

Description

This setpoint adjust latitude of "home" position. Home is position where gen-set should runs. Positions on

north hemisphere have positive value, position on south hemisphere have negative value.

Note: This value with Home Longitude (page 283) are used for counting Fence Radius 1 (page 284) and

Fence Radius 2 (page 284).

Note: This value can be also obtained automatically via logical binary input GEO HOME POSITION (PAGE

455). In case of activation of this binary input for at least 2 seconds, setpoint will be adjusted

automatically from actual coordinates from GPS signal.

Home Latitude

6 back to List of setpoints

Setpoint group CM-4G-GPS Related FW 1.2.1

Range [units] -180,0000..180,0000 [°]

Default value 0,0000 ° Alternative config NO

Step 0,0001 °

Comm object 14607 Related applications AMF, MRS

Config level Standard

Setpoint visibility Only if relevant module is installed

Description

This setpoint adjust longitude of "home" position. Home is position where gen-set should runs. Positions on

east hemisphere have positive value, position on west hemisphere have negative value.

Note: This value with Home Latitude (page 283) are used for counting Fence Radius 1 (page 284) and

Fence Radius 2 (page 284).

Note: This value can be also obtained automatically via logical binary input GEO HOME POSITION (PAGE

455). In case of activation of this binary input for at least 2 seconds, setpoint will be adjusted

automatically from actual coordinates from GPS signal.

Home Longitude

6 back to List of setpoints

ComAp InteliLite MRS16 User Manual

Other manuals for ComAp InteliLite MRS16