InteliLite Global Guide
290
Subgroup: Analog Input 4
Setpoint group Sensors Spec Related FW 1.2.1
Range [units] the range is defined by analog sensor curve
Default value
0 (number of decimal is
given by sensor curve)
Alternative config NO
Step the step is defined by analog sensor curve
Comm object 8793 Related applications AMF, MRS
Config level Standard
Setpoint visibility Always
Description
Calibrating constant to adjust the measured value of controller analog inputs. Physical dimension of
calibrating constant is corresponding to Analog input.
Note: Unit is adjusted via LiteEdit2015 in configuration of analog input 4.
Analog Input 4 Calibration
6 back to List of setpoints
Group: Alternate Config
Subgroup: Basic settings
Setpoint group Basic settings Related FW 1.2.1
Range [units] Monophase / Splitphase / 3Ph3Wire / High Leg D / 3Ph4Wire / Autodetect [-]
Default value 3Ph4Wire Alternative config YES
Step [-]
Comm object 12058 Related applications AMF, MRS
Config level Standard
Setpoint visibility Always
Description
When logical binary input CONFIGURATION 2 (PAGE 450) isn’t active, then setpoint Connection type (page
157) has the same value as setpoint Connection Type 1 . Setpoint Connection type (page 157) can be
changed from both places - from Basic settings setpoint group and from Alternate Config setpoint group.
Connection Type 1
6 back to List of setpoints
To Next Page
Loading...
Need help?
General
