ComAp InteliVision 5 Global Guide

InteliVision 5 - Global Guide
43
4.13 How to Change Display Brightness
The brightness of display can be changed by holding Menu button and repeated pressing  or ¯. See the picture
below:
Two modes are available in InteliVision 5.To switch between Day or Night mode hold Menu button only.
Pictogram for day or night appears on the screen.
To change day or night brightness intensity:
Hold Menu button until day / night mode on the screens appear
Press and hold Menu button with or ¯to change brightness intensity
Note: Brightness setting has priority in this order: controller forced brightness InteliVision’s 5 analogue input,
keyboard. When the analogue input is used, small pictograms in brightness sub-menu appears. Display
backlight could be switched off (standby) due to Backlight Time. For recover any button has to be pressed (see
IV5 Settings) or in case of new incoming alarm, the display awakes from standby mode and backlight of the
display is activated.

ComAp InteliVision 5 Specifications

General

Brand	ComAp
Model	InteliVision 5
Category	Monitor
Language	English