Comelit 3360 - 5 E. Viewing the porter module call parameters; 6. Self-ignition; 6 A. Enabling;disabling self-ignition; 7. Default settings

EN
27
5E. Viewing the porter module call parameters
1. access programming mode, see page 5
2. select the menu items:
Settings ⇒ System parameters ⇒ Speaker parameters
⇒ Advanced options ⇒ Call ⇒ View
TRIPLE CALL
CONFIRMATION T
CODES BOOSTER
ANSWER WAIT TIME 60
CONFIRMATION TONE
CODES BOOSTER
ANSWER WAIT TIME
VIEW
OK OK
SCROLL ESC
3. press or to confi rm
SELF IGNITION
*YES
NO
OK OK
SCROLL ESC
This function is enabled by default.
1. access programming mode, see page 5
2. select the menu items:
Settings ⇒ System parameters ⇒ Speaker parameters
⇒ Advanced options ⇒ Self ignition
6. Self-ignition
6A. Enabling/disabling self-ignition
S SERIAL
VOICE MESSAGES
CALL
SELF IGNITION
OK OK
SCROLL ESC
PARAMETER
CHANGED
7A. Restoring the default values of the porter
module
1. access programming mode, see page 5zselect the
menu items:
Settings ⇒ System parameters ⇒ Speaker parameters
⇒ Advanced options ⇒ Default settings
7. Default settings
This function is used to restore the default settings:
De-misting heating element = disabled
Audio-visual messages = disabled
Door lock command on SE in AC
Door lock time = 2 sec + tone disabled
C.NC.NO relay in parallel with SE
Lock release always enabled
Actuator function on S serial line = disabled
Answer wait time = 60 sec
Conversation time = 90 sec
Self-ignition = enabled
Confi rmation tone on user call = enabled
Reset wait time = 10 sec
Send call = single
Control of internal units connected to porter module = up
to 70
System mode = Simplebus
3. press or to confi rm
4. select YES to enable the function, NO to disable it
5. press
or to confi rm
» * indicates active selection
» confi rmation tone