CommScope ERA UAP2 - Page 33

18. Connect the cables from the splice box to the UAP2 SFP+ modules. Depending on the conguraon,
there may be one cable (Primary) or two cables (Primary and Secondary).
19. If using a PSU, connect the PSU cable to the connector on the UAP2.
20. Aach the UAP2 to the splice box base plate.
a. Align the keyhole opening on the splice box mounng plate with the buon on the AP mounng
plate.
b. Insert the AP into the splice box mounng plate slot and slide unl the AP plate meets the tabs on
the splice box plate.
c. Tilt up the drop rail bar to insert the UAP2 in the ceiling le cut out.
DRAFT: CONFIDENTIAL
Chapter 4: Mount the Fiber UAP2
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 33