CommScope ERA UAP2 - Page 32

14. Aach the splice box plate to the splice box with the four screws included in the mounng kit.
15. Aach the base plate to the UAP2 .
16. Insert the SFP+ modules in the UAP2 Primary and Secondary ports. Depending on the conguraon, one
or two SFP+ modules (Primary and Secondary) may be required.
17. Li the UAP2 to the splice box plate.
DRAFT: CONFIDENTIAL
Chapter 4: Mount the Fiber UAP2
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 32