CommScope ERA UAP2 - Page 35

5. Aach the U-bracket to the wall with four anchor screws.
Note: The anchor screws are not provided by CommScope. Follow the local building codes to
determine the anchor screw and torque required.
6. For AC power conguraons only, aach the PSU L-bracket to the U-bracket using the four M4 screws
provided in the mounng kit.
7. For AC power conguraons only, aach the PSU to the L-bracket using the four M4 screws provided in
the mounng kit.
DRAFT: CONFIDENTIAL
Chapter 4: Mount the Fiber UAP2
CommScope ERA
®
UAP2 with Fiber Interface Installaon Guide , Release
P/N M0203AB, DRAFT Rev D 35